Filter
Top Products
Appendix D: IP-Based and Chassis Management Parameters Transition Networks
Table 25: Media Device Parameters
Parameter IP based Chassis Description
9
The aging time (in seconds) for entries in
the forwarding database of the switch.
Aging Time
(Forwarding DB)
9 9
Factory Defaults This erases all configuration data and sets
the Device to factory default settings.
9
Flush FDB Flushes all forwarding database entries.
9
Flush VLAN DB Flushes all VLAN database entries.
9
Histogram Mode This determines what frame types are
accounted for in the port counters. The
choices are “count only RX frames” or
TX frames or both.
9
IEEE 802.1p priority mapping. The value
in this field is used as the priority of the
frame if it has the tag ‘n.’
IEEE Priority class
'n' [0-7]
9
IP priority remapping. The value in this
field is used as the priority of the frame if
its IP TOS bits have a traffic class value
between 0x00 and 0xE0, with 1 --> 0x00,
2 --> 0x04,...64 --> 0xE0.
IP Traffic class 'n'
[1-64]
9 9
Reset Counters Resets all port counters to zero.
Table 26: Port Configuration Parameters
Parameter IP based Chassis Description
9 9
Admin Status The administrative status of the interface
should be enabled for normal operation.
When the admin state is disabled, the port
goes into listening mode, the link will be
UP, but the interface does not forward
frames.
9 9
Advt 10 Full
Duplex
Enable/disable advertising full duplex
and 10Mbps capability on this port.
9 9
Advt 10 Half
Duplex
Enable/disable advertising half duplex
and 10Mbps capability on this port.
9 9
Advt 100 Full
Duplex
Enable/disable advertising full duplex
and 100Mbps capability on this port.
9 9
Enable/disable advertising half duplex
and 100Mbps capability on this port.
Advt 100 Half
Duplex
9 9
Enable/disable advertising
Advt Pause
capability
Pause
capability on the interface.
Continued on next page
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 131