Filter
Top Products
Section ll: FBRM/BFFG Hardware Installation Transition Networks
Installing fiber and copper cables
Warning
Use of controls, any adjustments, or the performance of procedures other than
those specified herein may result in hazardous radiation exposure.
Visible and invisible laser radiation when open: DO NOT stare into the laser-
light beam or view the beam directly with optical instruments. Failure to
observe this warning could result in an eye injury or blindness.
Fiber cable
To install the fiber cable, do the following:
Step Action
1. Locate a 100/1000Base-FX/SX/LX compliant fiber cable with male,
two-stranded connectors installed at both ends. See Figure 14.
2. Connect the fiber cables to the FBRM or BFFG Devices as shown in
Figure 14.
Figure 14: Fiber Cable Installation
Continued on next page
20