Filter
Top Products
3.2 Stacking Units in Rack or on Table
NOTE: StackMaster™TR 16-Port Units are shipped with attached brackets
for standard 19-inch rack installation and with attachable feet for table-top
installation.
3.2.1 Standard 19-Inch Rack Installation
CAUTION: The StackMaster™TR 16-Port Unit with the SNMP
Management Board must be installed at the top of the stack. Failure to
observe this caution will invalidate the SNMP network management.
NOTE: Rackmount screws and clip nuts are NOT provided with the
StackMaster™TR 16-Port Units.
To install the StackMaster™TR 16-Port Stack in a standard 19-inch rack:
1. Locate four (4) screws (and clip nuts, if necessary) for each
StackMaster™TR 16-Port Unit to be installed.
2. Locate the StackMaster™TR 16-Port Unit to be installed at the
bottom of the stack.
3. Carefully align the StackMaster™TR 16-Port Unit between the 19-
inch rack mounting rails at the lowest installation position.
4. Install two screws through right front bracket and two screws
through left front bracket, using clip nuts if necessary.
5. Carefully align the next StackMaster™TR 16-Port Unit above the
StackMaster™TR 16-Port Unit already installed.
6. Repeat steps 4 and 5 in reverse order until all StackMaster™TR
16-Port Units have been installed.
StackMasterTR
3-2