Filter
Top Products
3.2.2 Table-Top Installation
NOTE: StackMaster™TR 16-Port Units are shipped with a separate,
unattached set of adhesive-backed rubber feet.
CAUTION: The rubber feet MUST BE INSTALLED on the
StackMaster™TR 16-Port Unit if a StackMaster™TR 16-Port Unit is
installed on a table-top or other flat surface. Failure to observe this
caution could cause the StackMaster™TR 16-Port Unit to overheat and
could result in data transmission failure and/or equipment damage.
CAUTION: The StackMaster™TR 16-Port Unit with the SNMP
Management Board must be installed at the top of the stack. Failure to
observe this caution will invalidate the SNMP network management.
To install the StackMaster™TR 16-Port Stack on table or other flat surface:
1. Determine StackMaster™TR 16-Port Unit to be installed at
bottom of stack.
2. Carefully turn StackMaster™TR 16-Port Unit to side and install
four (4) rubber feet:
• Remove protective paper from adhesive surface of rubber
foot.
• Position rubber foot at bottom corner of Lanmaster Unit
• Secure rubber foot to StackMaster™TR 16-Port Unit.
• Repeat for remaining rubber feet.
3. Return StackMaster™TR 16-Port Unit to upright position.
4. Repeat step 2 for next StackMaster™TR 16-Port Unit to be
installed.
5. Carefully set StackMaster™TR 16-Port Unit on StackMaster™TR
16-Port Unit previously installed.
6. Continue steps 4 and 5 until all StackMaster™TR 16-Port Units
have been installed.
NOTE: The mounting brackets that come installed on the StackMaster™TR
16-Port Unit can be removed and saved for later use.
33.. IINNSSTTAALLLLAATTIIOONN
3-3
USER’S GUIDE