Filter
Top Products
Initial Configuration
TUT Systems, Inc Page 22 of 104 P/N 220-06288-20
Initial Configuration
There are five steps required for the initial configuration of the SMS2000:
1.
Step 1 Change the password for security purposes.
2.
Step 2 Set the Quick Configuration.
3.
Step 3 Change the system hostname to identify the system on the network.
4.
Step 4 Disable authentication.
5.
Step 5 Save the configuration.
6.
Step 6 Reboot the system.
7.
Step 7 Verify connectivity.
For advanced configuration information, see the SMS2000 User’s Guide.
For information on using OCS with the SMS2000, see the OCS User’s Guide.
Changing Your Password
You are encouraged to change the initial configuration password, “manager,” after your
initial login to the SMS2000. Perform the following steps to change your password:
1. At the system prompt enter:
sms2000% passwd
2. Press <Enter>.
3. Enter your new password.
4. Press <Enter>.
The system asks you to verify your password.
5. Reenter your password.
6. Press <Enter>.
Note:
If you forget your password at any time, please call your Tut Systems
Customer Service representative to assist you in logging on again.
You must have access to the serial port and have a phone nearby when contacting
Customer Service to bypass your password.
Setting the Quick Configuration
To reset the entire system configuration, using the IP address, network mask, default
gateway, and DNS servers specified in the basic system configuration, use this command:
set quick-config {ip_address/masklen | ip_address netmask ip_mask} gateway
dns[dns] [dns]