Authentication
TUT Systems, Inc Page 55 of 104 P/N 220-06288-20
The alias parameter can be combined with the multiple RADIUS servers to provide fault-
tolerant clustered RADIUS servers. RADIUS server configuration to support this is not
covered by this documentation as server configurations can vary widely.
Set NAS port type parameter
Beginning with SMS2.3.6, the system administrator can set the NAS type parameter to
any supported NAS type. If the NAS type parameter is not set, the default value of 5 will
be used.
To set the NAS type parameter, type:
Set nas-port-type <integer>
For example, to set the NAS port type to be used for a Wireless network, you will enter
the following command:
Set nas-port-type 19
NAS port type values are specified in RFC2865 section 5.1. They are:
0 Async
1 Sync
2 ISDN Sync
3 ISDN Async V.120
4 ISDN Async V.110
5 Virtual
6 PIAFS
7 HDLC Clear Channel
8 X.25
9 X.75
10 G.3 Fax
11 SDSL - Symmetric DSL
12 ADSL-CAP - Asymmetric DSL, Carrier less Amplitude Phase Modulation
13 ADSL-DMT - Asymmetric DSL, Discrete Multi-Tone
14 IDSL - ISDN Digital Subscriber Line
15 Ethernet
16 xDSL - Digital Subscriber Line of unknown type
17 Cable
18 Wireless - Other
19 Wireless - IEEE 802.11