Filter
Top Products
Authentication
TUT Systems, Inc Page 46 of 104 P/N 220-06288-20
Configuring the Command Server
Setting the Command Server for OCS
Interaction
To set the command server for the OCS interaction, use this command:
set cmd-serv ip_address
For example, to set the command server to 10.228.10.251, type:
sms2000% set cmd-serv 10.228.10.251
Note: This is normally not necessary if you use the auth add web command
with the cmd-serv option when adding the OCS.
Deleting the Command Server
To delete the command server, use this command:
delete cmd-serv ip_address
For example, to delete the command server with the IP address 10.228.10.251, use this
command:
sms2000% delete cmd-serv 10.228.10.251
Note:
This is normally not necessary if you use the auth delete web command.
Authentication
Adding the OCS as the Authentication
Server
Use the auth add web command to configure a Web-based authentication server (OCS).
When subscribers connect, they are redirected to the specified page on the server. The
server then authenticates and redirects the subscriber to the specified URL in the
SMS2000 for network access. You can also configure the authentication server as a
command server by entering the cmd-serv option of auth add web. This is required for
the OCS.