Filter
Top Products
System Administration
TUT Systems, Inc Page 27 of 104 P/N 220-06288-20
Note:
Some types of changes, including adding a static port with the set port
command or resetting the system configuration with the set quick config
command require that you reboot the SMS2000 before continuing.
Automatically Committing Configuration
Changes
To commit configuration changes to the running system immediately after they are
entered without having to enter the commit command, use this command:
commit auto
For example to force all configuration changes to be executed immediately, type:
sms2000% commit auto
Note:
Some commands cannot be committed without saving and rebooting.
When one of these commands is issued, the SMS2000 displays a warning to the
system administrator and disables the automatic commitment of commands.
Note:
You can determine the state of the autocommit feature by checking its
value at the bottom of the show config screen.
Disabling Automatic Configuration
Changes
Use the commit noauto command to disable the commit auto command and revert to
using commit manually. This allows commands that are not already
dynamic/instantaneous to be queued for batch mode execution.
For example, some of the commands that are not dynamic are:
delete dns load sys set quick-config
dump-info set default set time
system set dns set timezone
load config set port
To disable the automatic commitment of configuration commands, use this command:
commit noauto
For example, to set the systemto not commit changes until the commit command is
issued, type:
sms2000% commit noauto
Note:
Changes to the running system will be lost upon reboot, unless you enter
the save command.