Filter
Top Products
76
Using Tone-Out
Fire Tone-Out Introduction
Your scanner can be set to respond to fire tone-outs
that use standard two-tone sequential paging, short
one-tone paging, and long group tone paging. You can
save up to 10 settings. When you select a setting in
standby mode, the scanner also monitors for any other
setting that uses the same transmit frequency,
modulation, and attentuation settings.
You need tone-out setup information from the agency
you wish to monitor.Check with your local agency or
on-line resources.
Setting Tone-Out Standby
Tone-Out for...
Tone-Out Standby
Turn the scroll control to select the tone-out to monitor.
All tone-outs that have the same frequency,
modulation, and attenuation setting as the one you
select, are also monitored.
In standby mode, the display cycles through all
monitored tone-out settings.Regardless of the current
display, the scanner always alerts on any received
tone-out that matches a stored setting.
If you press HOLD while in standby mode, the scanner
temporarily exits the mode and you hear all
transmissions on that frequency. No alerts sound,
even if a tone-out matches one you have stored. Press
HOLD again to return to standby mode.
Setting Up Tone-Out
Tone-Out for ...
Tone-Out Setup
Scroll to select the tone-out (1 - 10) you want to
program, then press E
YES. Then you can scroll to any
of the following settings and press E
YES to select and
modify the selected settings:
Menu
Menu
Using Tone-Out