Filter
Top Products
108
AM
FM
NFM
WFM
WFM
Srch/CloCall Opt
Set Attenuator
On
Off
Srch/CloCall Opt
Set Data Skip
On
Off
Off
— the scanner uses AM (amplitude modulation) for the frequency band.
— the scanner uses FM (frequency modulation) for the frequency band.
— the scanner uses narrowband FM for the frequency band.
— the scanner uses wideband FM for the frequency band.
(Broadcast) — the scanner uses FM Broadcast for the frequency band.
Turn on this setting if you are near other strong signal sources. Attenuation
sometimes helps to reduce interference and desensitization that strong signals
create.
[MENU]
This setting controls the attenuator for Quick Search and Close Call operation.
Select your setting, then press .
— Reception is attenuated by about 20 dB.
— The attenuator is off.
This setting controls how the scanner behaves when it stops on a channel that has a
data signal.
— the scanner stops briefly on the channel, but then immediately resumes
scanning automatically.
— the scanner remains on the channel until the transmission stops. The default
setting is .
If you are trying to test the Close Call feature with a nearby transmitter (such
as a CB) and you do not talk into the transmitter, the scanner detects this
unmodulated carrier as data and skips the frequency when Data Skip is on. Turn the
feature off or talk into the transmitter to modulate the carrier.
This setting is ignored for AM/WFM/FMB channels.
Setting Attenuation
Setting Data Skip
gQ g
Qg
gQ g
Qg
[MENU]
Note: