Filter
Top Products
80
Q
Q
Edit Siteg
Select a site
Select from the following choices
— the system is scanned when its quick key is enabled.
— the system is locked for this session.
— the system is not scanned.
Select a trunked system
Select a site
This setting controls how many seconds the scanner looks at a site before moving
to the next unlocked site or system. Using the number keypad, enter a value from
0-255, then press to save the setting.
If the scanner cannot detect a control channel on an EDACS or Motorola
system, it immediately moves to the next site or system. The scanner always
scans LTR or SCAT systems for at least 1 second to check for current activity.
If you select 0 and the control channel is received, the scanner stays on the
system for a minimal time (only long enough to check current system activity).
The default setting is 2 seconds for each system.
The scanner moves to the next system after the hold time expires, any current
transmission ends, and the channel delay time expires.
In order for the scanner to scan Motorola VHF and UHF sites, you must enter
parameters that allow the scanner to determine the frequencies in use by the
system. This information is normally available at the same source where the other
system information is found.
Select a Motolora Type II/P25 system
Q
Q
Q
Q
Q
Q
Q
Q
Set Lockout
Unlocked
Temporary L/O
Lockout
Program System
Edit Site
Set Hold Time
Program System
Edit Site
g
gg
g
g
g
g
gg
g
g
Setting Site Hold Time MESL
Editing the Band Plan M (VHF and UHF only)
[MENU]
Notes:
[MENU]
!
!
!