Filter
Top Products
2
Installing the Unitech PT600/630 Scanner
1. Insert your Furniture Wizard CD into your computer’s CD-ROM
drive.
2. When the Installer opens up, click on Install Furniture Wizard.
3. After agreeing to the license agreement, click on “Install
Additional Components”
4. Follow the instructions on the screen, by clicking “Next”
5. The necessary files will now be copied over to your computer.
6. Take the cable that was included along with your PT600 Scanner
and plug into an available Serial port on your computer. Note
which serial port your scanner is plugged into.
7. Plug in the included power supply into an available outlet, and
plug the other end into the serial cable for the scanner.
8. You will now need to check the port settings for your Comm port.
a. For Windows 98/ME
i. Open up your control panel, and double-click on
the System icon.
ii. Click on the Device Manager tab in the top.
b. For Windows 2000/XP
i. Open up your control panel, and double-click on
the System icon.
ii. Click on the Hardware tab, and click on the
Device Manager icon.
9. Under Ports (COM&LPT) find “Communications Port (Comm X)”.
The X will be the Comm port associated with your Serial port,
usually 1 or 2
10. Note the Comm port in parentheses. This is the Comm port that
you will need to enter into Furniture Wizard in order to use the
PT600 Scanner.
11. Double-Click to open the settings for the Comm port.
12. Click on the “Port Settings” tab.
13. Change the settings to match the following
a. “Bits Per Second” --------------------------------------57600
b. “Data Bits”-------------------------------------------------------8
c. “Parity”------------------------------------------------------None
d. “Stop Bits”--------------------------------------------------------1
e. “Flow Control”----------------------------------------Hardware
14. Click OK to save the settings.
15. Close the Device Manager.