Filter
Top Products
1. Setup the RAID Array prior to driver installation and boot up
to Windows.
2. At the Found New Hardware Wizard, select No, not this
time, then click Next.
3. Insert the driver CD, select Install the software
automatically (Recommended), and click Next.
4. Click Finish.
5. Restart Windows to complete the driver installation.
UGT-ST310R Page 18
F
For Windows® Vista
or A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents
of the “UGT-ST310R\2000_XP_2003_Vista\32bit” folder,
found on the driver CD, onto a blank floppy disk then
follow the directions below.
1. Setup the RAID Array prior to Windows installation.
2. Follow Microsoft’s Windows installation procedure.
3. At the Windows Setup screen, press Load Driver to install
the RAID driver.
4. Insert the floppy disk, please select Silicon Image SiI 3114
SoftRAID 5 Controller (A:\si3114r5.inf), then press Next.
(Change A:\ to match your floppy drive letter)
5. Follow the on-screen instructions to complete the Windows
installation.
For An Existing Installation
1. Setup the RAID Array prior to driver installation and boot up
to Windows.
2. At Found New Hardware Wizard, select Locate and
install driver software (recommended).