Filter
Top Products
UGT-ST310R Page 19
F
To Verify Windows® Installation
1. Right click My Computer and click Manage.
3. Please insert driver CD, click Next.
4. Click Close to complete the installation.
For Windows® Vista-x64
or A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents
of the “UGT-ST310R\XP_2003_Vista\64bit” folder, found
on the driver CD, onto a blank floppy disk then follow the
directions below.
1. Setup the RAID Array prior to Windows installation.
2. Follow Microsoft’s Windows installation procedure.
3. At the Windows Setup screen, press Load Driver to install
the RAID driver.
4. Insert the floppy disk, please select Silicon Image SiI 3114
SoftRAID 5 Controller (A:\si3114r5.inf), then press Next.
(Change A:\ to match your floppy drive letter)
5. Follow the on-screen instructions to complete the Windows
installation.
For An Existing Installation
1. Setup the RAID Array prior to driver installation and boot up
to Windows.
2. At Found New Hardware Wizard, select Locate and
install driver software (recommended).
3. Please insert the driver CD, click Next.
4. Click Close to complete the installation.