Filter
Top Products
UGT-ST310R Page 5
Note: There are six SATA ports in 6-Port SATA II 150 PCI Host
Card w/RAID. We name these ports from A through F. Ports A to
D are internal SATA ports. Ports E and F are external SATA ports.
Changing the jumper settings allows you to select between
external and internal ports to use. By default, Port A, B, C and D
are working.
Hardware Installation
1. Turn Off the power to your computer and any other
connected peripheral devices.
2. Unplug the power cord form the back of the computer.
3. Remove your computer’s cover.
4. Remove the slot bracket from an available PCI slot.
5. To install the card, carefully align the card’s bus connector
with the selected PCI slot on the motherboard. Push the
board down firmly, but gently, until it is well seated.
6. Replace the slot bracket’s holding screw to secure the card.
Device Connection
The 6-Port SATA II 150 PCI Host Card w/RAID is a four channel
Serial ATA controller that supports up to four Serial ATA hard disk
drives. It is recommended to use identical hard drives for all
RAID configurations.
1. Install your hard disk drive(s) in chassis.
2. Connect the Serial ATA hard disk drive to the system power
supply using the included Serial ATA power cable.
3. Connect one end of the Serial ATA cable to the hard disk