Filter
Top Products
Controls and Functions
Vidikron Vision Model 110 Owner’s Operating Manual 7
PRE
L
IMINAR
Y
5. LEFT BUTTON
Used to direct-select inputs or move the menu cursor left in the OSD. When no menu is
present on-screen, the LEFT button toggles through the different sources, in this order:
HDMI 2 - HDMI 1 - HD3 (VGA/Y-Pb-Pr) - HD 2 (BNC) - HD 1 (RCA) - S-Video - Composite
(VID)
6. UP BUTTON
Use to direct-select aspect ratios or move the menu cursor up in the OSD. When no
menu is present on-screen, the UP button toggles through aspect ratios in the following
order:
16:9 - 4:3 - Letterbox - IntelliWide - Cinema - IntelliWide 2.35
(IntelliWide 2.35 is available only on CineWide-equipped projectors. For more
information about aspect ratios, refer to
Table 4-1.)
7. DOWN BUTTON
Use to direct-select aspect ratios or move the menu cursor down in the OSD. When no
menu is present on-screen, the DOWN button toggles through the different aspect
ratios, in this order:
IntelliWide 2.35 - Cinema - IntelliWide - Letterbox - 4:3 - 16:9
8. RIGHT BUTTON
Used to direct-select inputs or move the menu cursor right in the OSD. When no menu is
present on-screen, the RIGHT button toggles through the different sources, in this order:
Composite (VID) - S-Video - HD 1 (RCA) - HD 2 (BNC) - HD 3 (VGA/Y-Pb-Pr) - HDMI 1 -
HDMI
2
9. STAND-BY LED
Lights orange to indicate that the projector is in standby mode.
10. SOFT POWER BUTTON
Press once to turn on the Vision 110. Press it again to put the projector into Standby
mode. For a discrete on or off command, you can use the direct access buttons on the
remote control (see
Figure 2-4).
11. PATTERN BUTTON
Press PATTERN to access the internal test pattern menu. Use arrow keys to select a
pattern and press SELECT to confirm. Press PATTERN again to return to the selected
source.
12. POWER INPUT (100 to 240 VAC)
Connect the Vision 110 to power here.
13. SERVICE PORT
For use by authorized service personnel only.
14. SELECT BUTTON
Press SELECT to confirm your selection of a highlighted choice on the On-Screen Display
(OSD).
15. MENU BUTTON
Pressing the MENU button brings up the main Vision 110 menu. Also, if you are in an
adjustment mode or function, pressing MENU brings the menu back one level.
16. INPUTS
Connect your video sources and other equipment to these inputs. Refer to Vision 110
Rear Connector Panel on page 8.