ViewSonic PJ513DB Projector User Manual


 
ViewSonic 39 PJ513D/PJ513DB
Warning message
When the Lamp indicator lights up red or a message appears suggesting it is time to
replace the lamp, please install a new lamp or consult your dealer. An old lamp may
cause a malfunction in the projector and in some instances the lamp may explode.
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too
hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator
still lights up after turning the power back on, please contact your dealer. See "Indicators" on
page 42 for details.
The following Lamp warning displays will remind you to change the lamp.
Message Status
The lamp has been in operation for 2000 hours.
Install a new lamp for optimal performance. If
the projector is normally run with "Economic
Mode" selected (See "Lamp Mode (Normal)"
on page 35), you may continue to operate the
projector until the 2950 hour lamp warning
appears.
The lamp has been in operation for 2950 hours.
A new lamp should be fitted to avoid the
inconvenience when the projector runs out of
lamp time.
The lamp has been in operation for 3000 hours.
It is strongly recommended that you replace the
lamp at this age. The lamp is a consumable
item. The lamp brightness diminishes with use.
This is normal lamp behavior. You can replace
the lamp whenever you notice that the
brightness level has significantly diminished. If
the lamp is not replaced beforehand, it must be
replaced after 3000 hours usage.
The lamp MUST be replaced before the
projector will operate normally.
OK
Order Replacement Lamp
Lamp > 2000 Hours
Notice
OK
Replace Lamp Soon
Lamp > 2950 Hours
Notice
OK
Replace Lamp Now
Lamp > 3000 Hours
Lamp usage time exceeded
Notice
OK
Out of Lamp-Usage Time
Replace lamp (refer to User manual)
Then reset lamp timer
Notice