Filter
Top Products
16
Powering Off the Projector
1. Press the “ ” button on the control panel or on the remote control to turn off
the projector. The following message will be displayed on the screen.
Press the “ ” button again to conrm.
2. The Power LED will turn red and blink rapidly after the projector is turned off.
And the fans will continue to operate for about 30 seconds to ensure that the
system cools properly.
3. Once the system has nished cooling, the Power LED will stop blinking and turn
solid red to indicate standby mode.
4. It is now safe to unplug the power cord.
LED Indicator Messages
Message
Lamp LED
(Red)
Temp LED
(Red)
Power LED
(Red)
Power LED
(Blue)
Power Plug
Flash ON to OFF
100ms
Flash ON to OFF
100ms
Flash ON to OFF
100ms
-
Standby - - ON -
Power button ON - - - ON
Cooling state - -
0.5 second H(ON),
0.5 second L(OFF)
ashing
-
Power button OFF:
Cooling completed; Standby Mode
- - ON -
Firmware download ON ON ON -
Thermal sensor error, OSD showing as
below:
1. Make sure air in and outlets are not
blocked.
2. Make sure the environment temperature
is under 40 degree C.
- ON - ON
Fan lock error, OSD showing as below:
The projector will switch off automatically.
-
0.5 second H(On),
0.5 second L(Off)
ashing
- ON
Lamp error (LED, LED driver, Light sensor) ON - - ON