Filter
Top Products
User’s Manual 3-25
TECRA A10/S10/M10/SatellitePro S300
Installing a memory module
To install a memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the Turning off the power section in Chapter 1, Getting Started if
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in Chapter 6, Power and Power-Up
Modes, if required).
5. Loosen the one screw securing the memory module cover in place -
please note that this screw is attached to the cover in order to prevent it
from being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
Figure 3-8 Removing the memory module cover
7. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 45 degree angle before
holding it down until the latches on either side snap into place.
Figure 3-9 Seating the memory module
Use a point size 0 Phillips screwdriver.
Screw
Memory module
cover
Slot A
Slot B
Notch