Filter
Top Products
VXI Technology, Inc.
30 CT-100C Installation
RACKMOUNT DOOR KIT INSTALLATION
The rackmount door kit (Option 60) provides the necessary hardware to install a 1/8” thick
aluminum door in front of the rackmounted chassis. This option requires that the rackmount ear
kit also be installed and configured for recessed mounting. The door may be customer modified to
hold connectors, controls, indicators and similar components.
Required Tools
1. #2 Phillips Screwdriver
2. 1/8" Flat Blade Screwdriver
3. 11/32" Open Ended Wrench
Parts List
QTY ITEM VTI P/N
2 Screw, 6-32 x 1/2” Pan Head Ph, Sq Cone Sems Zinc 37-0028-050
2 Nut, Hex, 6-32, Zinc/Steel 37-0030-632
1 Latch, Vise Action, Know Style, Black 37-0065-000
2 Hinge, Adjustable Damping, Black 37-0066-000
8 Screw, 8-32 x 3/8” Pan Head Phil, M/S, Blk Zinc 37-0079-037
4 Screw, 8-32 x 3/8” Flat Head Phillips, Zinc 37-0080-037
1 Latch, Door, Rackmount, CT-100C 41-0133-000
1 Door, Front, Rackmount, CT-100C 41-0134-000
2 Brace, Rackmount, CT-100C 41-0136-000
Assembly Procedure
1. Lay the chassis on a protected work surface on its long side with the voltage monitor LEDs of
the chassis facing front with the power switch toward the top.
2. Locate two rackmount (cross) braces. Install one each along the front of the flanges (one on
top and one on the bottom) using four (two ea.) #8 flathead screws. The lip along the long
edge of each brace goes toward the front and pointing inside. The braces fit over the flanges
and the screws are placed from the inside going through the flange and then into the brace.
3. Locate the front door and two hinges. Install the two hinges to the front door using four black
screws provided.
4. Locate the latch kit and install it into the door from the side where the hinges are mounted.
5. Locate the door latch bracket and install it on the rackmount ear opposite the end where the
hinges will be installed. Use
Figure 1-6 as a reference.
6. Locate the four tapped holes on the front surface of the rackmount ear to which the door is to
be attached.
7. Install the door by its hinges to the rackmount ear using four black screws provided with the
option kit.
8. Test that the door opens and closes smoothly and adjust the latch as necessary to secure the
door when latched close.