Filter
Top Products
3.3 Label Roll Installation
1. Open the printer panels and the print head lift lever
2. Rotate the Label Guide clockwise away from the Media Guide Bar
3. Insert a new label roll into the label spindle
4. Pull labels leading edge forward under the black media guide bar,
through the gap/black mark sensor and place the label leading edge onto
the Platen Roller
Figure 10: Insert a label roll into label spindle.
Figure 11: Media guide bar the gap/black mark detector
5. Adjust the label guide by sliding it along its bar to meet the width of the
label. Then rotate the Label Guide counter-clockwise and secure it to the
Media Guide Bar
6. Adjust the Gap Detector to overlap at least one inch of the label by moving
the yellow Gap Detector Handle located under the media and just in front
of the media guide bar
7. Close the print head lift lever
8. Close the lower front panel and printer cover
9. Turn the power on
10. Go to section 4.2 Gap / Black Mark Detector Sensor Calibration and
calibrate the labels
Media Guide
Bar
Gap / Black
Mark
Detector
Label
Guide
Platen
Roller
Label
Spindle
Gap
Detector
Handle
Label
Guide
Print Head
Lever