Western Digital WDBWVL0160KBK Server User Manual


 
TROUBLESHOOTING
77
WD SENTINEL DS5100/DS6100
ADMINISTRATOR AND MAINTENANCE GUIDE
Imminent
Failure Boot
Drive <Drive
Name>
S.M.A.R.T early detection found a
premature drive failure condition on
one of the boot drives.
Replace the defective drive as soon
as possible to stop RAID from
going into a degraded state.
Invalid Drive The inserted drive is not compatible
with the device.
Replace the inserted drive with an
approved drive. See
Dashboard>Monitor> Tasks for a
list of approved drives.
Invalid Drive
Capacity
The new drive capacity is either
greater or smaller than the drive you
replaced.
Replace the inserted drive with a
drive that has the correct drive
capacity.
Network
Disconnected
The ethernet port does not have
network activity.
Restore network connectivity.
Power Supply
<Supply #>
Failed
Power supply 1 or 2 failed. Replace the defective power
supply.
Access the Dashboard (See
“Accessing the Dashboard” on
page 25.)
Click Monitor on the navigation
bar.
Check the Power Adapter area to
review the status of your power
supply.
Obtain and install a comparable
power supply.
Reboot
Required
The system requires a reboot. Safely reboot the system.
Software
Update
Complete
The software update process is
complete.
Check the Alert Viewer to verify the
completion of the software update.
Software
Update
Downloading
A software update is being
downloaded to the system.
Allow the process to fully complete.
No action is required.
Software
Update Reboot
Required
The software update is complete.
The system requires a reboot.
The reboot is normally automatic. If
it does not occur, perform a manual
reboot.
WD Software
Update
Available
There is a WD software update
available for download.
Access and perform the update.
Access the Dashboard (See
“Accessing the Dashboard” on
page 25.)
Click Monitor on the navigation
bar.
Click the Software Update tab.
Click Check for Updates.
Click Download and Install to
update the software.
WD Software
Update Failed
The WD software update failed. Repeat the Software update
process again.
LCD Description Troubleshooting