Filter
Top Products
Operation
2–4 975-0125-01-01
On Start Up
When the RS2000 is powered up or comes out of a reset state, all of the
front panel lights illuminate and remain on for a minimum of five
seconds. After five seconds, the lights remain illuminated until the front
panel has status information for all the lights.
The RS2000 is disabled every time the unit is powered up. The inverter
must then be enabled. When a function is disabled, it is not allowed to
occur and if it is occurring, it is terminated. Regardless of other
conditions, the function will not be activated. For example, even if AC
power is present, if the charger is disabled, the unit will not charge.
When a function is enabled, it is allowed to occur but other conditions
may have to be met before the function is activated or turned on. For
example, the charger function on the RS2000 may be enabled, but it will
not charge unless qualified AC power is present.
4 Fault light indicates a condition that requires user attention
and intervention. The Fault light illuminates when any
Xanbus-enabled device connected to the network is in fault.
See “Faults and Warnings” on page 4–2 for the definitions of a
fault and warning.
5 Enter button
• Confirms selection of a menu item.
• Moves you to the next screen.
6 Up arrow button
• Scrolls up one line of text.
• Increases a selected value.
7 Down arrow button
• Scrolls down one line of text.
• Decreases a selected value.
8 Exit button
• Cancels selection of a menu item.
• Returns you to the previous screen.
9 System button:
• Toggles all Xanbus-enabled devices on the system between
Operate mode and Power Save mode. See “System Modes”
on page 2–6.
10 Screen displays menus, settings, and system information.
Table 2-1
System Control Panel Features and Buttons
Feature Description