Filter
Top Products
6 IN-LINE STAPLER FINISHER USER GUIDE
Enabling the Finisher options
Once the Finisher printer driver has been installed on your workstation, you will need to
enable the Finisher options. The procedure for doing so varies by operating system.
Follow the instructions for the operating system you are running.
NOTE: The procedures in this section apply to the Document Centre ColorSeries 50
copier/printer only. To enable the Finisher options on the DocuColor 12 copier/printer, refer
to the product manual supplied by the manufacturer of the Digital Front End connected to
your DocuColor 12. The minimum software levels for the Splash and Fiery Digital Front
Ends are as follows:
To support the IOT finisher functionality, the Splash G610 system software must be at a
minimum of version 2.0.
To support the IOT finisher functionality, the Fiery XP12 and X12 system software must be
at a minimum of version 1.1.
Windows 2000
1 From the Start menu, select Settings > Printers > Xerox Document Centre CS 50 PS.
2 From the File menu, select Properties.
3 Select the Device Settings tab.
4 Under Installable Options, select Output Tray to display a drop-down options menu.
5 Select Finisher Output Tray + Mailbox.
6 Select OK to complete the installation.