XEROX WIDE FORMAT 510dp OPERATOR MANUAL 7
2. Powering on and off
This chapter describes the procedures for powering on and
powering off. It also describes the power consumption modes.
Powering on
To power on:
1. Switch the circuit breaker to the On (I) position. This turns on
power to the Printer.
2. Switch the printer power switch to the On (I) position. This
turns on the printer.
3. Switch on the Controller.
NOTE: During the warm-up cycle, the message display
provides a FUSER CALIBRATING message then a "printer is
warming up" message and decreasing fuser warm-up codes of
L9 to L0,. When the warm-up completes, the printer is on-line
and ready to print. The message display indicates, "XES
SYNERGIX 510dp IDLE."
Circuit breake
r
switch
Printer powe
r
switch
Controlle
r
power switch