Filter
Top Products
OFF-LINE SETUP MENU
24 XEROX WIDE FORMAT 510dp OPERATOR MANUAL
Specifying the finisher configuration type
Note: If there is a Scanner connected, the message displayed will
be SYNERGIX CS 510dp. If there is no Scanner connected the
message will be SYNERGIX PS 510dp.
To specify the finisher configuration type:
1. Access the PRINTER MENU. See "Accessing the Printer
Menu" in this chapter.
2. Press the Previous or Next key until FINISHER SETTINGS is
displayed.
3. Press the Enter key to select FINISHER SETTINGS.
4. Press the Enter key to select FINISHER CONFIG TYPE. The
current value for the FINISHER CONFIG TYPE option is
displayed.
5. Press the Previous or Next key to switch between NONE and
003.
6. Press the Enter key to save your selection.
7. Press the On-line/Off-line key to return to on-line mode.
• The on-line/off-line indicator will light.
• The display will indicate " SYNERGIX CS 510dp IDLE" or
"SYNERGIX PS 510dp"
Performing printer diagnostics
The DIAGNOSTICS option has two operator-accessible sub-
options – TEST PLOT and RECENT FAULT LOG.
NOTE: A third DIAGNOSTICS option, PRINTER DIAGNOSTICS,
is restricted to the service representative. If you select it, you will
be asked to enter a password. Press the Exit key to exit the
option.
Printing a test plot
Note: If there is a Scanner connected, the message displayed will
be SYNERGIX CS 510dp. If there is no Scanner connected the
message will be SYNERGIX PS 510dp.
To print a test plot:
1. Access the PRINTER MENU. See "Accessing the Printer
Menu" in this chapter.
2. Press the Previous or Next key until DIAGNOSTICS is
displayed.
3. Press the Enter key to select DIAGNOSTICS.
4. Press the Enter key to select TEST PLOT.
5. Press the Previous or Next key to scroll through the media
sources.
6. Press the Enter key to select the media source. The printer
will initialize the media supply and print the test plot.
7. Press the On-line/Off-line key to return to on-line mode.
• The on-line/off-line indicator will light.