PROBLEM SOLVING
XEROX WIDE FORMAT 510dp OPERATOR MANUAL 45
Error messages
The error messages shown in the table below may appear on the
message display. Follow the instructions in the table before calling
for service.
Table 3. Error Message Table
Error Message Problem Solution
CHECK FOLDER
FOLDER COMMUNICATIONS ERROR
#17
FINISHER CONFIG TYPE
enabled, but no folder is
installed.
1. Press the On-line/Off-line key to
take the printer off-line.
2. Reset the value to NONE.
Refer to "Specifying the finisher
configuration type" in this
manual for instructions.
F2-01 CHECK FOLDER
FOLDER COMMUNICATOINS ERROR
#01
FINISHER CONFIG TYPE
enabled, but no folder is
installed.
1. Switch the printer Off.
2. Wait five seconds. Then switch
the printer On.
3. As soon as the Printer
Firmware Version message is
displayed, press the On-
line/Offline key to take the
printer off-line.
4. Reset the value to NONE.
Refer to "Specifying the finisher
configuration type" in this
manual for instructions.