Filter
Top Products
Solving Print Quality Problems
5-34 ❖ User Guide
Unfused or partially
fused image
The printed image is not
fully fused to the paper
and easily rubs off.
Damp paper stock. Replace paper stock.
Heavy or unusual paper stock. Use only approved paper/media. (See
Table 2.1 on page 2-4).
Defective Fuser. Replace the Fuser. See the
System
Administrator Guide
on the printer CD for
ordering and installation instructions.
Improper paper/media type set
on control panel.
Set proper paper/media type.
Incorrectly configured fuser
temperature
Increase the fuser temperature setting.
Wrinkled prints
Prints are wrinkled,
creased, or torn.
Poor paper condition. Inspect/replace the paper stock.
Paper is damp. Replace paper stock.
Fuser is at its end of life Replace the Fuser. See the
System
Administrator Guide
on the printer CD for
ordering and installation instructions.
Table 5.3 Print Quality Problems
(continued)
Problem Possible Cause(s) Corrective Action(s)
Table 5.3 Page 6 of 8