Filter
Top Products
75 En
Adjusting the system parameters
ADVANCED
OPERATION
English
5 Press / to switch between “DEMO: ON”
and “DEMO: OFF”.
• Select DEMO: ON to activate the demo mode.
• Select DEMO: OFF to deactivate the demo mode.
6 Press STANDBY/ON on the remote control to
set this unit to the standby mode.
The new setting will be activated when you turn on
the power of this unit next time.
Press ENTER while playing back sources to test the
sound beam.
The sound beam being output shuttles between left
and right. Press ENTER again to stop shuttling.
You can disable the INPUT on the front panel when you
adjust the system parameters.
1 Repeat steps 1 to 3 in “Using the system
parameters” on page 71.
2 Set the operation mode selector to YSP.
3 Press / so that “PANEL INP. KEY” is
displayed in the front panel display.
4 Press ENTER.
ENTER
X DEMO:XXON
X DEMO:XXOFF
STANDBY/ON
Setting the PANEL INP. KEY
YSP
TV/AV
ENTER
PANELX INP.X KEY
ENTER