Filter
Top Products
77 En
Adjusting the system parameters
ADVANCED
OPERATION
English
5 Press / to switch between “F.PANEL:
ON” and “F.PANEL: OFF”.
• Select F.PANEL: ON to enable the front panel
keys.
• Select F.PANEL: OFF to disable the front panel
keys. “P.INPUT” is automatically set to “ON”.
6 Press STANDBY/ON on the remote control to
set this unit to the standby mode.
The new setting will be activated when you turn on
the power of this unit next time.
You can reset all of the parameters of this unit to the
factory presets. This procedure completely resets ALL the
parameters in SET MENU.
After performing the following procedure you must run AUTO
SETUP again to match your surround sound environment.
1 Repeat steps 1 to 3 in “Using the system
parameters” on page 71.
2 Set the operation mode selector to YSP.
3 Press / so that “FACTORY PRESET” is
displayed in the front panel display.
4 Press ENTER.
ENTER
X F.PANEL:X ON
X F.PANEL:X OFF
STANDBY/ON
Setting the FACTORY PRESET
Note
YSP
TV/AV
ENTER
FACTORYX PRESET
ENTER