Filter
Top Products
60 R110Xi/R170Xi User Guide 23063L-003 Rev. 2 12/23/04
Front Panel Controls
Front Panel LCD
ZebraNet
®
Wired and Wireless Print Server LCD Displays
The menu options shown in Table 8 display only if you have the ZebraNet PrintServer II, or
10/100 PrintServer, or Wireless Print Server installed.
Table 8 • Print Server LCD Displays
Parameter Action/Explanation
LOAD LAN FROM?
1
This parameter, which serves the same function as the ^NP ZPL command, specifies
whether to use the printer’s or the print server’s IP settings at bootup.
Accepted Values: PRINTER, PRINTSERVER
Default Value: PRINTER
WIRED PS
CHECK?
1
This parameter, which serves the same function as the ^NB ZPL command, tells the
printer whether to search for a wired print server at bootup.
Accepted Values: YES, NO
Default Value: NO
IP PROTOCOL
2
IP Protocol
Allows either the user (permanent) or the server (dynamic) to select the IP address.
If a dynamic option is chosen, this selection determines the method(s) by which the
print server receives the IP address from the server.
• Press the right or left oval to display other choices.
Default: ALL
Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP, DHCPAND
BOOTP, PERMANENT
Note • Use of GLEANING ONLY is not recommended when the Wireless Print
Server is installed.
IP ADDRESS
2
IP Address
This parameter allows you to select the IP address if PERMANENT was chosen in
IP PROTOCOL. (If a dynamic option was chosen, the user cannot select the
address.)
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.
SUBNET MASK
2
Subnet Mask
This parameter selects the part of the IP address that is considered to be part of the
local network. It can be reached without going through the default gateway.
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.