Filter
Top Products
37
RW Series User Guide
WLAN Module Using 802.11b/g Radio
The following section only applies when the 802.11b/g WLAN module (With FCC ID: I28MD-ZLAN11G) is
installed in a RW series printer). Other than conditions specified elsewhere in this manual, only one of the
radio options can be installed in the printer at one time and the antenna used for these transmitters must not
be co-located or must not operate in conjunction with any other antenna.
RW Series models have the FCC ID number on a label on the back of the unit.
Caution • Use of a RW series printer with the radio module marked
with FCC ID: I28MD-ZLAN11G meets the FCC requirements for
radio frequency (RF) radiation exposure in the standard body worn
configuration with no minimum separation. In this configuration, which
applies whether the belt clip or shoulder strap is used, the face of the
printer from which paper is transported is facing away from the user’s
body. The standard configuration must always be used when the printer
is body worn.
The RW 220 and RW 420 printers with this radio option have
been SAR tested. The maximum SAR value measured for
each model is listed below:
Model
SAR value W/Kg (1g average)
)
RW220 0.004
RW 420 0.004
European Regulatory Information for this Radio
AT BE CY CZ DK
EE FI FR DE GR
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE GB
Note: -Member states in the EU with restrictive use for this device are
crossed out!
This device is also authorized for use in all EFTA member states (CH, IS, LI, NO
)
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU and
EFTA member states except in France where
restrictive use applies.
continued