Filter
Top Products
The Zebra T300 printer uses the Windows™-based BAR-ONE software or
ZPL II Programming Language commands. To install BAR-ONE software:
1. Start Windows.
2. Insert disk 1 of the BAR-ONE software in your floppy disk drive (A: or
B:).
3. In Program Manager, click on the File menu. Select Run. (Windows 95
users: select Run from the Start menu.)
4. Type A:\SETUP (or B:\SETUP) and then press OK.
5. Follow the on-screen instructions to complete the installation.
To create a label for the Zebra T300, you may either use the BAR-ONE soft-
ware to create the label format or write one in ZPL II , which is Zebra’s pro-
gramming language for creating labels. If you are using BAR-ONE
software, refer to the on-line BAR-ONE instructions. If you are using, or
plan to use, the ZPL II programming language to format your labels, make
sure you have a copy of the ZPL II Programming Guide. Refer to the mail-in/
fax-in card at the back of this book to obtain a copy, if desired.
The operator tears off each label (or a strip of labels) as
it is printed.
The backing material is peeled away from the label as it
is printed, the printer waits until the operator removes the label, then the next
label is printed.
(Available only with Optional Cutter Module.) Each label
is cut automatically after it is printed.
(Requires use of thermal transfer ribbon.) The printer
transfers ink/wax from a ribbon onto the media to form an image.
547000r1 Page 14 Tuesday, March 25, 1997 11:38 AM