Filter
Top Products
Print density 203 dots/inch 8 dots/mm
Print width 1 to 4.125 25.4 mm to 105.0 mm
Print speed 2 /sec, 1.5 /sec 51 mm/sec, 38 mm/sec
Label width (including back-
ing material, if any)
1 to 4.65 25 mm to 118 mm
Label length 0.5 to 18 13 mm to 457 mm
Interlabel gap 0.08 to 0.16 2 mm to 4 mm
Label thickness (including
backing material, if any)
0.003 to 0.010 0.076 mm to 0.254 mm
Label roll
size
Max. outer
diameter
4.0 102 mm
Min. inner core
diameter
1.0 25.4 mm
Registration
tolerance
Horizontal ± 0.059 ± 1.5 mm
Vertical ± 0.0393 ± 1.0 mm
First dot location (from outer
media edge)
0.060 to 0.140 1.5 mm to 3.5 mm
Ribbon roll
size
Max. outer
diameter
1.5 38 mm
Min. inner core
diameter
0.50 13.0 mm
Physical size (L W H) 10.1 8.8 6.2 257 mm 224 mm 158 mm
Weight (without media) 7 lb 3.18 kg
Tempera-
ture range
Operating 40° to 100° F 4° to 38° C
Storage -4° to 140° F -20° to 60° C
Relative humidity, operation
and storage
10 to 90% R.H.
Media requirements Zebra recommends using Zebra-brand thermal transfer media
that is outside-wound (the label or printing surface is wound on
the outside of the backing). Media may be roll or fanfold,
transmissive or reflective (black-mark) sensing; continuous,
die-cut, or notched. Notched media: notch must be 1/4 wide
3/ long located on the left side of the label as viewed from
the front of the printer. Black-mark media: marks must be
located within 1 mm of the left edge of the media as viewed
from the front of the printer; mark thickness: 0.12”-0.43” (3
mm - 11 mm); mark width: 0.43” (11 mm) - full media width;
mark-to-mark leading edge registration tolerance ±0.016”
(±0.4 mm); mark density > 1.0 ODU (Optical Density Unit);
maximum density of the back of the media on which the black
mark is printed: 0.5 ODU.
547000r1 Page 24 Tuesday, March 25, 1997 11:38 AM