Thermal-Transfer TLP Model
Before following the steps in this
procedure, open the printer by
pulling the release latches forward then
lifting the top cover. Remove any ribbon
from the carriage.
Removal
1. Grasp the print head spring and pull it
to the left; then, slide it free of the
carriage.
2. Use the spring to pry the print head
clip off the right side of the carriage.
3. Pull the print head and bracket
forward.
4. Use a #2 Phillips driver to remove the
screw that holds the ground wire.
5. Unplug both bundles of print head
wires from their connectors.
32 980485-001A
MOVIE