Filter
Top Products
P320i Plastic Card Printer
Card
Printer
Solutions
General information
Getting started
Operation
Cleaning
Specifications
Appendix A
Appendix B
Troubleshooting
Printing a card
Appendix C
C - CARD THICKNESS CONTROL LEVER
This item is operated by the user to prevent more than one card feeding
into the printer at the same time and causing a jam.
D - CARD OUTPUT HOPPER
For collecting printing cards.
Install Card Output Hopper onto printer by
hooking over bottom edge of card exit
aperture.
Card Thickness:
A - 60mil (1.524mm) to 50mil
(1.27mm)
B - 40mil (1.016mm)
C - 30mil (0.762mm)
* Start at lowest position and move
lever up to match card thickness.
For other card thickness, start lever
at lowest position and move up
until cards feed.
Open Cover, and adjust lever to correct
position. Repeat for different card thickness.
(Factory setting is for 30mil (0.762mm) card
thickness. See diagram below: