Filter
Top Products
Operation & Options
This section helps you get the most from your printer.
You must use programming to control many of the printer’s functions. A
few examples:
■
The
~JL
command controls label length.
■
The
^XA^MTD^XZ
command changes the printing mode to direct
thermal; the
^XA^MTT^XZ
command changes the printing mode to
thermal transfer.
■
The
^XA^JUS^XZ
command saves the new settings to flash memory.
For detailed information about creating labels using ZPL II, refer to the ZPL
II Programming Guide or visit our web site at www.zebra.com.
To improve print quality, changing both print speed and density may be
required to achieve the desired results. Your application’s printer driver
provides control of the speed and heat (density).
Thermal Printing
The print head becomes hot while printing. To protect from damaging the
print head and risk of personal injury, avoid touching the print head. Use
only the cleaning pen to perform maintenance.
The discharge of electrostatic energy that accumulates on the surface of the
human body or other surfaces can damage or destroy the print head or
electronic components used in this device. You must observe static-safe
procedures when working with the print head or the electronic components
under the top cover.
You must use the correct media for the type of printing you require. When
printing without a ribbon, you must use direct thermal media. When using
ribbon, you must use thermal transfer media. The printer’s ribbon sensor
detects motion of the supply spindle.
980476-001A 21