Filter
Top Products
30 Zebra Z4M/Z6M Printers User’s Guide
3RZHU3HHO5HZLQG5HZLQG0RGH
(Power rewind option required)
Refer to Figure 19.
1. Press the printhead open lever. The printhead assembly springs up.
2. Flip down the media supply guide.
3. Slide out the media guide as far from the printer frame as possible.
4. Place the roll of media on the media supply hanger and orient the media properly.
5. Flip up the media supply guide.
6. Slide in the media supply guide so that it just touches, but does not restrict, the
edge of the roll.
7. Feed the media under the dancer, through the slot in the transmissive sensor, and
under the ribbon sensor.
8. Pull approximately 36" (915 mm) of media through the front of the printer.
9. Remove the labels from the first 18" of media so that only the liner remains.
10.Ensure that the media is against the back of the transmissive sensor. Slide in the
media guide so that it just touches, but does not restrict, the edge of the media.
11.Feed the media over the value peel assembly and through the rewind base
assembly.
12.Loosen the thumbscrew and slide out the rewind media guide to the end of the
take-up spindle.
13.Slide an empty core onto the take-up spindle; wrap the media around the core and
turn the take-up spindle counterclockwise to wind up the excess material.
NOTE: The liner must be attached to the take-up spindle for the printer to
operate properly. Make sure the edge of the liner is flush against the backplate
of the take-up spindle (see “Rewind Media Alignment” on page 67 for details).