Filter
Top Products
40 Zebra Z4M/Z6M Printers User’s Guide
&RQILJXUDWLRQDQG&DOLEUDWLRQ6HTXHQFH
Display Shows Action/Explanation
PRINTER READY Normal printer operation.
Setting Print Parameters
DARKNESS
Adjusting Print Darkness: Press the INCREMENT (+) key to increase darkness.
Press the DECREMENT (–) key to decrease darkness.
Default: +10
Range: 0 to +30
Darkness settings are dependent upon a variety of factors, including ribbon type,
media, and the condition of the printhead. You may adjust the darkness for
consistent high-quality printing.
If printing is too light, or if there are voids in printed areas, increase the darkness. If
printing is too dark, or if there is spreading or bleeding of printed areas, decrease
the darkness.
The FEED Key Self Test on page 78 can also be used to determine the best
darkness setting. Since the darkness setting takes effect immediately, you can see
the results on labels that are currently printing.
CAUTION: Set the darkness to the lowest setting that provides good print
quality. Darkness set too high may cause ink smearing and/or it
may burn through the ribbon.
Darkness settings may also be changed by the driver or software settings.
TEAR OFF
Adjusting the Tear-off Position: Press the INCREMENT (+) key to increase the
value, press the DECREMENT (–) key to decrease the value. Each press of the
key adjusts the tear-off position by four dot rows.
Default: +0
Range: –120 to +120
This parameter establishes the position of the media over the tear-off/peel-off bar
after printing. The label and liner can be torn off or cut between labels.