Filter
Top Products
32 Zebra Z4M/Z6M Printers User’s Guide
)DQIROG0HGLD/RDGLQJ
Fanfold media feeds through either the bottom or rear access slot.
Refer to Figure 20.
1. Press the printhead open lever. The printhead assembly springs up.
2. Flip down the media supply guide.
3. Slide out the media guide as far from the printer frame as possible.
4. Pass the fanfold media over the media supply hanger.
5. Flip up the media supply guide. Slide in the media supply guide so that it just
touches, but does not restrict, the edge of the media.
6. Thread the media under the dancer, through the slot in the transmissive sensor,
under the ribbon sensor, and out the front of the printer.
7. Ensure that the media is against the back of the transmissive sensor. Then, slide in
the media guide so that it just touches, but does not restrict, the edge of the media.
8. Close the printhead assembly.