Filter
Top Products
14 ADSL Bridge Modem User’s Guide
If you are not prompted for a user name and password, do
the following in this order: Recheck all connections; restart
the modem and computer; and reset the modem by
inserting a paper clip into the Reset pinhole in the center
of the modem’s back panel and holding it for five seconds.
The user name and password you enter here do not serve
the same purpose as any name and password that your
Internet service provider may have given you.
3
33
3
The Zoom Configuration Manager opens and begins to
automatically configure itself. This is evident because the
Basic Setup page will open and quickly change to the
Autodetect page. To specify your Internet service provider’s
VPI and VCI settings, you must set the modem for manual
configuration. Do the following:
a
aa
a
Click the Stop button to stop the modem from trying to
automatically configure itself.
b
bb
b
Select the Disable option button, then click Save
Changes. The page changes, and the MANUALLY
option button is selected.
c
cc
c
Enter the VPI and VCI settings into the appropriate
boxes. These values should have been given to you by your
Internet service provider.
d
dd
d
Click the Save Changes button, then click the Write
Settings to Flash button.
4
44
4
Close Zoom Configuration Manager by closing your Web
browser.
5
55
5
Change your computer’s TCP/IP settings from the values you
specified in step 1 to those given to you by your Internet
service provider. Besides changing the IP address, Subnet
mask, and Default gateway values, you must enter an
additional value: DNS. This, too, should have been provided
by your Internet service provider. For more information about
specifying these settings, see Chapter 3: Specifying TCP/IP
Settings on page 15.
Continue with Testing Your Internet Connection on page 9.