Filter
Top Products
TCP/IP Configuration 47
configure Static Routes if some services reside beyond the immediate
remote LAN.
Remote Node Setup
Follow the procedure in Chapter 5 to fill the protocol-independent
parameters in Menu 11, Remote Node Profile. For the protocol-
dependent parameters, follow the instructions below.
1. Route - Make sure IP is among the protocols in the Route field.
2. IP Address - Enter the IP address of the gateway at the remote
site (in this case, headquarters). If the remote router is using a
different IP address than the one entered here, your Prestige will
drop the call.
Edit IP/IPX/Bridge - Press the space bar to change it to Yes and
press Enter to go to the Menu 11.3 - Remote Node Network Layer
Options menu shown below:
Figure 6-2 Menu 11.3 - Remote Node Network Layer Options
1. Rem IP Address - This will show the IP address you entered for
this Remote Node in the previous menu.