Prestige 2602HWNLI-D7A Support Notes
All contents copyright (c) 2007 ZyXEL Communications Corporation.
129
dial tone from ISDN again. At this state you can dial out to ISDN as you would on a regular ISDN system.
Relay to ISDN
The Relay to ISDN field can be found under ISDN configuration WEB GUI in Relay to ISDN section. This
field is used to specify phone numbers to which the Prestige will always send calls through the regular ISDN
phone service without pushing prefix. In other words, numbers which specify on this field do not need to dial
prefix number to be dialed out. However, these numbers must be for phones on the ISDN (not VOIP phones)
and currently, P2602WNLI –67A support up to nine entries under this field.
After configuring the ISDN setup, click “Apply” to save changes back to P2602WNLI.
Note: It is recommended to configure your local emergency services such as Police Dept, Fire Dept, and
Emergency Medical services phone number in this field. Thus in any cases, these unit can be reach in case of
emergency by dialing their number without prefix, regardless if there are power loss.
How to connect Lifeline and DSL connection
To use both VOIP and regular phone service with P2602WNLI’s lifeline feature. You will need to connect
ADSL line and phone line appropriately and make proper configuration.
Making the correct connection it allows you to still receive phone calls while someone else is making outgoing
VoIP call though Prestige’s 1 ISDN phone port, the following figure shows you how to connect your phone and
DSL service.
If your ADSL line type is Splitter type you ISP will provide you with splitter otherwise it should be splitterless.
For correct info you may check with your service provider as for which type of line you have.