Filter
Top Products
Installation 3
2
Installation
This chapter describes how to install your Comet hardware. Installation procedures
also cover Windows 3.x, Windows 95, Windows NT 4.0, and DOS operating systems.
Hardware
You can insert your Comet with your computer turned on or off. Follow the steps
below to complete the hardware installation:
1. Hold the card label up and insert the card into the computer's PCMCIA slot with
the 68 pin connector facing the computer.
2. Plug the 15-pin PC Card connector with both RJ-45 LAN cord and RJ-11
telephone cord into the 15-pin socket on the PC Card. Now the hardware
installation is completed. The PC Card is powered directly by the PC.
3. Connect the RJ-45 (8-pin) plug to the LAN and the RJ-11 (6-pin) plug to the
telephone wall outlet.
Non-Windows 95 & Windows NT Operating Systems
Novell Netware Installation
Follow the steps bellow to complete Novell Netware installation:
1. Insert the driver diskette into the floppy drive and set to the appropriate drive
(A:\). Then type
INSTALL
and press
Enter
.
2. Select
Netware 3.x and 4.x Workstation
from the installation program dialog
box.
3. Check the card settings. If current settings are correct, select
Start Installation
and go to step 5. Otherwise, select
Modify Parameters
to change settings.
4. Select the appropriate values then press
Enter
. When you are finished, press
OK
to exit.