Filter
Top Products
13
To enable firmware updates:
1. Enter the host PC’s IP address, User Name, Password, Image Path, and Image Name in the
data-entry files
.
2. Click Update Firmware to store the new firmware changes.
Note: The red reminder s only appear if you update setting in Configuration/System Setup page.
4.3.3 System Log Windows
The System Log window logs system events for detail descriptions of system status log. This is very useful to
track system. It shows important successful states and critical system logs.
Figure 4-6 System log
If you didn’t specify SNTP/NTP server IP address in Configuration/System Setup page, there won’t be any
timestamp in system log. The following lists all system logs in A-6000.
Watch dog reboots system.
Firmware programming failed.
Error while saving configuration parameters.
5. Hardware Installation
5.1. A-6000 office test
It is recommended that you test the system in office before you r outdoor installation. Please be noticed that
the power for each unit should be set as ”min” at the first time for your system link with antennas connected
to the units. After you access the web page and read the RSSI value, the reading should be in the range
between –45 to –61. The physical cable connection of theA-6000 for office test is shown as the following
diagram: