Filter
Top Products
Ethernet Switch CLI Reference Guide
195
CHAPTER 54
Running Configuration
Commands
Use these commands to back up and restore configuration and firmware.
54.1 Switch Configuration File
When you configure the Switch using either the CLI (Command Line Interface) or web
configurator, the settings are saved as a series of commands in a configuration file on the
Switch called running-config. You can perform the following with a configuration file:
• Back up Switch configuration once the Switch is set up to work in your network.
• Restore a previously-saved Switch configuration.
• Use the same configuration file to set all switches (of the same model) in your network to
the same settings.
You may also edit a configuration file using a text editor. Make sure you use valid commands.
" The Switch rejects configuration files with invalid or incomplete commands.
54.2 Command Summary
The following table describes user-input values available in multiple commands for this
feature.
Table 113 running-config User-input Values
COMMAND DESCRIPTION
attribute Possible values: active, name, speed-duplex, bpdu-control,
flow-control, intrusion-lock, vlan1q, vlan1q-member,
bandwidth-limit, vlan-stacking, port-security, broadcast-
storm-control, mirroring, port-access-authenticator,
queuing-method, igmp-filtering, spanning-tree, mrstp,
protocol-based-vlan, port-based-vlan, mac-authentication,
trtcm, ethernet-oam, loopguard, arp-inspection, dhcp-
snooping.