Filter
Top Products
ZyXEL G-202 User’s Guide
62 Chapter 5 Access Point Mode Configuration
5.1.2 Additional Setup Requirements
To bridge your wired and wireless network using the G-202, the following requirements must
be met:
1 The G-202 must be installed on a computer connected to the wired network.
2 Either bridge the two interfaces (wireless and wired) on the computer (using the
Configuration screen of the ZyXEL utility in Windows XP) or configure network
sharing (refer to Appendix B on page 75 for an example).
3 Set the wireless station’s IP address to be dynamic if you want the wireless stations to
access the wired network or the Internet through the G-202. Refer to Appendix E on page
97 for how to configure your computer’s IP address.
5.2 The Link Info Screen
Select the AP Mode check box and wait for about five seconds to display the screen as shown.
Figure 39 Access Point Mode: Link Info
The following table describes the labels in this screen.
Table 16 Access Point Mode: Link Info
LABEL DESCRIPTION
Status
SSID This field displays the name that identifies your G-202 in the wireless LAN network.