Filter
Top Products
Omni 56K II and Omni 56K Plus II User’s Guide
Command Sets 5-17
All other +F commands are not supported, but the modem will respond OK. In many cases this means "don't
care."
Table 5-10
Class 2 Command Responses
RESPONSE VALUE FUNCTION AND DESCRIPTION
+FCFR Confirmation.
+FCIG:"string" Reports the remote ID response CIG.
+FCON Facsimile connection response.
+FCSI:"string" Reports the remote ID response CSI.
+FDCS:vr,br,wd,ln,df,
ec,bf,st
Reports the session parameters response; refer to the +FDCC=....
command.
+FDIS:vr,br,wd,ln,df,
ec,bf,st
Reports the session negotiation parameters response; refer to the
+FDCC=.... command.
+FDTC:vr,br,wd,ln,df,
ec,bf,st
Reports the remote capabilities response; refer to the +FDCC=....
command.
+FET:n Message response for a received page; refer to the +FET=n command
in Table 5-9.
Call termination status response.
n=00 Normal and proper end of connection.
n=10 Transmit error on phase A hang up code.
n=20 Transmit error on phase B hang up code.
n=40 Transmit error on phase C hang up code.
n=50 Transmit error on phase D hang up code.
n=70 Receive error on phase B hang up code.
n=90 Receive error on phase C hang up code.
+FHNG:n
n=100 Receive error on phase D hang up code.
+FNSC:"HEX string" Reports the non-standard facilities command frame.
+FNSF:"HEX string" Reports the non-standard facilities frame response.
+FNSS:"HEX string" Reports the non-standard setup frame response.
+FPOLL Remote polling indication.
+FPTS:n Receive a page transfer status response; refer to the +FPTS=n
d