Filter
Top Products
P314 Broadband Sharing Gateway with 4-Port Switch
2-2 Hardware Installation and Setup
LEDs Function Indicator
Status
Active Description
Off The WAN Link is not ready, or has failed.
On The WAN Link is ok.
WAN WAN Green
Flashing The 10M WAN link is sending/receiving packets.
2.2 Prestige 314 Rear Panel and Connections
The following figure shows the rear panel of your Prestige 314 and the connection diagram.
Figure 2-2 Prestige Rear Panel and Connections
This section outlines how to connect your Prestige 314 to the LAN and the WAN. In the case of connecting a
cable modem you must connect the coaxial cable from your cable service to the threaded coaxial cable
connector on the back of the cable modem. Connect an xDSL Modem to the xDSL Wall Jack. Please also
see
the Appendices
for important safety instructions on making connections to the Prestige.
Step 1: Connecting the Console Port
For the initial configuration of your Prestige, you need to use terminal emulator software on a workstation
and connect it to the Prestige through the console port. Connect the 9-pin (smaller) end of the console cable
to the console port of the Prestige and the 25-pin (bigger) end to a serial port (COM1, COM2 or other COM