Filter
Top Products
P314 Broadband Sharing Gateway with 4-Port Switch
Remote Node Setup 4-3
4.1.2 PPPoE Encapsulation
The Prestige supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use PPPoE encapsulation
when you’re using the Prestige with an xDSL modem as the WAN device. If you change the
Encapsulation
to
PPPoE,
then you will see the next screen. Please see
the Appendices
for more information on PPPoE.
Figure 4-2 Menu 11.1 Remote Node Profile for PPPoE Encapsulation
The following table describes the fields NOT already described in
Table 4-1
already.
Table 4-2 Fields in Menu 11.1 (PPPoE Encapsulation Specific Only)
Field Description Examples
Telco Option:
Allocated Budget
The field sets a ceiling for outgoing call time for this remote
node. The default is 0, meaning no budget control.
10
Period(hr)
This field is the time period that the budget should be reset.
For example, if we are allowed to call this remote node for a
maximum of 10 minutes every hour, then the
Allocated
Budget
is (10 minutes) and the
Period(hr)
is 1 (hour).
1
Idle Timeout
This value specifies the idle time (i.e., the length of time
there is no traffic from the Prestige to the remote node) in
seconds that can elapse before the Prestige automatically
disconnects the PPPoE connection. This option only applies
when the Prestige initiates the call
.
100
seconds
(default)
Menu 11.1 - Remote Node Profile
Rem Node Name= ChangeMe Route= IP
Active= Yes
Encapsulation= PPPoE Edit IP= No
Service Type= Standard Telco Option:
Service Name= Allocated Budget(min)= 0
Outgoing= Period(hr)= 0
My Login=
My Password= ********
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 300
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.